#COMMAND PROMPT WINDOWS 10 VOLUME LIST HOW TO#
#COMMAND PROMPT WINDOWS 10 VOLUME LIST DRIVERS#
#COMMAND PROMPT WINDOWS 10 VOLUME LIST SOFTWARE#
#COMMAND PROMPT WINDOWS 10 VOLUME LIST FREE#

#COMMAND PROMPT WINDOWS 10 VOLUME LIST SOFTWARE#

Please note that this article references sites not owned or maintained by Veritas and, as such, Veritas is not responsible for the content portrayed on such sites, including any revisions to or deletions of content or third-party software on which this article relies. More information about additional Microsoft DiskPart commands can be found at the following Microsoft web page: LIST VOLUME - Displays a list of basic and dynamic volumes on all disks.ĭETAIL VOLUME - Displays the disks on which the current volume resides.ĮXIT - Exits the DiskPart command interpreter. Dynamic disks also contain a partition that occupies the remainder of the disk and reserves space for use by dynamic volumes.ĭETAIL PARTITION - Displays the properties of the selected partition. This discrepancy occurs because dynamic disks contain entries in the partition table for the system volume or boot volume (if present on the disk). On dynamic disks, these partitions may not correspond to the dynamic volumes on the disk. LIST PARTITION - Displays the partitions listed in the partition table of the current disk.

The disk marked with an asterisk (*) has focus.ĭETAIL DISK - Displays the properties of the selected disk and the volumes on that disk.

#COMMAND PROMPT WINDOWS 10 VOLUME LIST FREE#

LIST DISK - Displays a list of disks and information about them, such as their size, amount of available free space, whether the disk is a basic or dynamic disk, and whether the disk uses the master boot record (MBR) or GUID partition table (GPT) partition style. Below are a few of the more common commands used to determine disk information: Once booted into the System Recovery Disk, click ANALYZE, open a command prompt. The Microsoft DiskPart Utility provides a quick way to determine drive number designations when booted into WinPE. If diskpart does show the disks, but the recovery environment doesn't, there may be partition errors, the disk is not a valid target for restore, etc.

Substitute in the command above with the actual drive letter (ex: 'F') of the volume you want to unmount. (see screenshot below) mountvol : /P.

#COMMAND PROMPT WINDOWS 10 VOLUME LIST HOW TO#

Please refer to the user's guide for instructions on how to do this. 2 Type the command below into the elevated command prompt, and press Enter.

#COMMAND PROMPT WINDOWS 10 VOLUME LIST DRIVERS#

If diskpart does not see the disk information, it is possible the drivers for the disk controller need to be loaded.

Now your disk is write-protected and all its partitions turn into read-only.If the System Recovery Disk does not display disks, volumes, partitions or other drive information, DISKPART can be used to determine if WinPE sees the volume.

To set your chosen disk read-only, type attributes disk set readonly and press Enter.

Next type select disk #, where # is the number of the disk you want to make read-only. If you want to set the entire disk read-only, follow these steps:

If you want to clear ready-only attribute for your volume later, just repeat steps 1 through 2 above and then run this command: When you try to format that volume, you’ll get the error “ The disk is write protected“. Now, you’ll be unable to delete or modify the files on that volume.To make your selected volume read-only, type attributes volume set readonly and press Enter.Next type select volume #, where # is the number of the volume you’re going to lock it as read-only. Open the Command Prompt as administrator, and then run the diskpart command.How to enable write protection for a disk drive or set your volume read-only? How can I prevent a hard drive from being formatted? In this tutorial we’ll show you how to set a particular disk or volume read-only in Windows 10 / 8 / 7, without using any third-party software.

Command prompt windows 10 volume list